Reviving a 150-year-old Family Heirloom For A New Chapter!

Pictures of the progress that this beautiful table took from rag to riches.

We often forget to take photos of antiques that we work on in our excitement.  This time, we remembered to photograph the process and are so proud to share it with you.  We were almost as ecstatic as the customer when we showed them the big reveal!

This is how it used to look. It had a glass top which was removed before the photo but as you can see there is water damage which appears to have ruined the varnish.  On older pieces, if the varnish is ruined then there is very little we can do to restore it if water leak thru the varnish.  Other than restoring it, we were tasked with fixing a broken leg that had come clean off and hand carving a fourth leg that had broken and disappeared.

Sitting in the shop with 2 missing legs.
Before doing any work at all. One leg is missing and the other is laying on top. Only 2 of 4 legs remain.

Once in the shop we cleaned it best we could and began very lightly sanding the top of the table by hand. 

We had to be delicate since we didn’t know if the varnish was still present and if it was, how much was left. It’s important to only sand the varnish and never burn through to the original wood because then you lose the beautiful grain. In situations like this, dustless blasting Perth could be a suitable alternative, ensuring precise removal without damaging the underlying wood grain.

Close up of the overall condition of the top before we sanded. Notice at the bottom of the photo the large water stain.

Thankfully, as we hand sanded the top of the table the water stain didn’t ruin it.  We could see the beautiful texture of the original wood and the varnish was still intact.

The top layer of varnish is brown, and the underlying wood is the yellowish part you see in the photo.  The varnish was very easily sanded away like a fine dust because it was around 150 years old. (We did wear masks).

Please ignore the dusty fingerprints, those round white things are just from us moving it with dusty hands. This is a closeup of the beautiful wood grain that we found.
Side by side example. The foot that had fallen off served as a great example and we put it back on once we were done carving since it was easier to use it then the entire table.
We took the foot that had fallen off to a local lumber yard so that we could buy the same piece of wood in order to carve the fourth foot. Then we began the long process of carving a completely new foot that matched the other three.
Here we have the both feet put on the table and sanded down ready to stain it. It was actually more difficult to stain everything to look like it was never broken then it was to carve a whole new foot.

After we finished carving a new foot and attached both feet to the table we began sanding and staining the table. There were so many crevices that dust had accumulated over the last couple centuries, so the process was tedious but so very worth it.

Do you want to challenge yourself? Take a good look at both photos below and see if you can tell which foot was recently hand carved and which are original.

The picture above is dark because we did not finish staining yet. The top hasn’t been stained at all and the bottom still hadn’t gone through an antiquing process where we age it to look like the rest. We lightened the legs after the photo was taken.

Table is all finished with the stain, just applying final sealer and lacquer so that it can last another 100 years or so. Are you able to find which leg was hand carved recently?

Are you ready for the final photos?

Here they are!

Finished product waiting to be picked up

Waiting to be picked up from the client. The grain of this wood is just stunning. We were able to clean away all the dirt from the little crevices of every intricately carved piece of this remarkable table.

Get AutoBlogged